CYLINDER BLOCK - Inspection (Cont'd)
EM-190prose procedureInspection (Cont'd)
| Specification | Value |
|---|---|
| Nominal cylinder block height from crankshaft center "H"(7.4409 ± 0.0020 in) | 189.00 ± 0.05mm |
Nominal cylinder block height from crankshaft center "H"(7.4409 ± 0.0020 in)
189.00 ± 0.05mm
Cylinder Bore Inspection
- 2Using a bore gauge, measure cylinder bore for wear, out-of-round or taper.
EM124 - 3Check for scratches or seizure. If seizure is found, hone it.
| Specification | Value |
|---|---|
| Standard inner diameter(2.8740 - 2.8760 in) | 73.00 - 73.05mm |
| Out-of-round (X - Y) - Limit(0.0008 in) | 0.02mm |
| Taper (A - B) - Limit(0.0006 in) | 0.015mm |
Standard inner diameter(2.8740 - 2.8760 in)
73.00 - 73.05mm
Out-of-round (X - Y) - Limit(0.0008 in)
0.02mm
Taper (A - B) - Limit(0.0006 in)
0.015mm