Diagnostic Procedure 35 (Cont'd) - A.A.C. VALVE
EF & EC-507flowchartSR20DE. Idle speed spec 850 ± 50 rpm. Harness connectors differ between L.H.D. models (E225/E7, F7/F22) and R.H.D. models (E29/E6, F11/F21). CONSULT and non-CONSULT procedures both provided.
TROUBLE DIAGNOSES
Diagnostic Procedure 35 (Cont'd)
Diagnostic Procedure 35 - A.A.C. VALVE
1
INSPECTION START
2
A. CHECK OVERALL FUNCTION. 1) Start engine and warm it up sufficiently. 2) Check idle speed. 850 ± 50 rpm 3) With CONSULT: Perform "IGN TIMING ADJ" in "WORK SUPPORT" mode. Without CONSULT: Disconnect A.A.C. valve harness connector. 4) Make sure that idle speed drops.
Drops
INSPECTION END
Does not drop
3
B. CHECK POWER SUPPLY. 1) Stop engine. 2) Check voltage between terminal a and ground. Voltage: Battery voltage
N.G.
Check the following. - Harness connectors E225, E7 (L.H.D. models) - Harness connectors E29, E6 (R.H.D. models) - Harness connectors M11, M36 - 10A fuse - Harness continuity between A.A.C. valve and fuse If N.G., repair harness or connectors.
Check the following. - Harness connectors E225, E7 (L.H.D. models) - Harness connectors E29, E6 (R.H.D. models) - Harness connectors M11, M36 - 10A fuse - Harness continuity between A.A.C. valve and fuse If N.G., repair harness or connectors.
O.K.
4
C. CHECK OUTPUT SIGNAL CIRCUIT. With CONSULT: 1) Reconnect A.A.C. valve harness connector. 2) Perform "AAC VALVE OPENING TEST" in "ACTIVE TEST" mode with CONSULT. OR Without CONSULT: 1) Disconnect E.C.U. harness connector. 2) Check harness continuity between E.C.U. terminal 113 and terminal b. Continuity should exist.
N.G.
Check the following. - Harness connectors F7, F22 (L.H.D. models) - Harness connectors F11, F21 (R.H.D. models) - Harness continuity between E.C.U. and A.A.C. valve If N.G., repair harness or connectors.
Check the following. - Harness connectors F7, F22 (L.H.D. models) - Harness connectors F11, F21 (R.H.D. models) - Harness continuity between E.C.U. and A.A.C. valve If N.G., repair harness or connectors.
O.K.
5
(continues on next page)
