Checking Exhaust Gas Sensor
MA-27flowchartChecking Exhaust Gas Sensor
1
INSPECTION START
2
Start engine and warm it up until water temperature indicator points to middle of gauge.
3
Run engine at about 2,000 rpm for about 2 minutes under no-load.
4
Check voltage between ground and the terminal on check connector. Make sure that needle of voltmeter fluctuates between approx. 0 and battery voltage, more than 5 times in 10 seconds at 2,000 rpm.
N.G.
Check and adjustment should be made by referring to Checking and Adjusting Idle-rpm, Ignition Timing and Mixture Ratio in section EF & EC.
Check and adjustment should be made by referring to Checking and Adjusting Idle-rpm, Ignition Timing and Mixture Ratio in section EF & EC.
Start engine and warm it up until water temperature indicator points to middle of gauge.
Run engine at about 2,000 rpm for about 2 minutes under no-load.
Check voltage between ground and the terminal on check connector. Make sure that needle of voltmeter fluctuates between approx. 0 and battery voltage, more than 5 times in 10 seconds at 2,000 rpm.
O.K.
INSPECTION END
See also
Checking and Adjusting Idle-rpm, Ignition Timing and Mixture Ratio (EF & EC)